Scissor Lift Certification Guelph

Scissor Lift Certification Guelph - Scissor lift platforms are used at work locations to enable tradespeople - like for example welders, masons and iron workers - to reach their work. Utilizing a scissor lift platform is typically secondary to their trade. Therefore, it is important that all platform operators be correctly trained and certified. Regulators, industry and lift manufacturers work together in order to make sure that operators are trained in safely utilizing work platforms.

Scissor lift work platforms are also called manlifts or AWPs. These work machines are somewhat easy to use and provide a steady work surroundings, nevertheless they do have risks since they lift people to heights. The following are various key safety concerns common to AWPs:

In order to protect people working around work platforms from accidental discharge of power because of close working proximities to wires and power lines, there is a minimum safe approach distance (MSAD). Voltage can arc across the air and cause injury to employees on a work platform if MSAD is not observed.

To be able to guarantee maximum stability, care should be taken when the work platform is lowered. When you move the load towards the turntable, the boom must be retracted. This will help maintain steadiness in lowering of the platform.

Regulations do not mandate people working on a scissor lift to tie off. However, workers may be needed to tie off if needed by employer guidelines, local regulations or job-specific risk assessment. The manufacturer-provided anchorage is the only safe anchorage to which harness and lanyard combinations must be attached.

It is essential to observe and not go beyond the maximum slope rating. The grade could be measured by laying a straight edge on the slope or by laying a board. A carpenter's level can then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope could be determined.

A typical walk-around check has to be carried out to determine if the unit is mechanically safe. A location assessment determines if the work area is safe. This is essential especially on changing construction locations due to the risk of obstacles, unimproved surfaces, and contact with power lines. A function test must be performed. If the unit is used properly and safely and correct shutdown measures are followed, the chances of incident are greatly reduced.

Click to Download the pdf